GE JV247 - Manual (Page 10)

10
REMOVE EXHAUST ADAPTOR
If exhausting/venting using the 3 1 ⁄
4
″ x 10″ rectangular
duct—optional for JV247, JV248, JV338, JV347, JV348
and JV367 models only:
Remove the exhaust adaptor from the inside of the hood.
Set it aside along with its mounting screws.
3 1 ⁄
4
″ x 10″
rectangular
exhaust
adaptor
and screws
REMOVE FILTER
Remove the shipping tape holding the metal grease
filter in place. Pull down on the center of the front edge
of the filter. The filter will then slip out of the retaining
tabs on the back.
REVERSE THE BAFFLE FOR DUCTED
INSTALLATIONS ONLY (JV247, JV248,
JV347, JV348 and JV367 models)
If the hood is to be recirculated, skip to the next step.
Remove the baffle from the top of the hood. Reinstall
the baffle so the short side marked “VENTED” is visible.
The long side of the baffle should be inside the hood.
REMOVE WIRING COVER
Remove the wiring cover from inside the hood.
Set the cover and its mounting screws aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp
2
3
4
5
6
Metal grease filter
Installation Instructions
Back knockout Top knockout
“VENTED” is visible
Strain relief
clamp
REMOVE DUCT KNOCKOUT
If recirculating, non-vented ductless (JN327 and RN328,
and optional for JV247, JV248, JV347, JV348 and JV367
models only), skip to Step 11 D and proceed.
Using a flat-blade screwdriver, remove the appropriate
duct knockout from the top or back of the hood.
3 1 ⁄
4
″ x 10″ Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
7
″ Round vertical
discharge. Remove circular
duct knockout only.
3 1 ⁄
4
″ x 10″ Rectangular
horizontal discharge. Remove
rear rectangular duct knockout only.
7