GenTran R6010 - Manual

1
POWER CENTER
For Models R2060, R3060, R5010, R2020, R3020, R5020,
R6010, R6020, R1020, R1220
All models are suitable as service entrance equipment.
INSTALLATION AND OPERATING INSTRUCTIONS
Warning
: Gen/Tran transfer switches should be installed by a professional electrician familiar with electrical wiring and codes, and experienced in working
with generators. Gen/Tran accepts no responsibility for accidents, damages or personal injury caused by incorrect installation. These transfer switches are
intended for surface mounting outdoors or indoors.
Caution
: If using the generator and transfer switch for larger appliances, such as electric water heaters, clothes dryers, electric ranges and small air
conditioners, check the labels on the appliances to be sure they do NOT exceed the rating of the generator. No appliance should have an amperage rating that
exceeds the “GENERATOR MAIN” rating in the transfer switch.
Thank you for purchasing the finest manual transfer switch available today. Gen/Tran’s Power Centers are designed to safely connect generators to load centers
in homes and light commercial buildings (single phase only) for standby power applications. Features include:
♦ Generator Main and Utility Main mechanically interlocked preventing utility or generator power back feed
♦ Full branch circuit protection with Siemens
® circuit breakers
♦ Optional GFCI, Arc Fault or Surge Protection circuit breakers to further protect your home and electronic equipment (Available from Gen/Tran)
♦ High Corrosion-resistant aluminum cabinet
Items Needed for Installation:
♦ ¼” and 11/32 nut drivers
♦ Straight blade and Phillips screwdriver
♦ Large Allen Wrench Set
♦ Electric drill
♦ Wire cutter/stripper
♦ Anchors and screws to mount switch to wall
♦ Power Cord to connect generator to switch.
Typical Power Center Installation: