GE ZET3038 - Manual (Page 37)

37
Oven
light bulbs
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
CAUTION
: Before replacing your
oven light bulb, disconnect electrical power
to the oven at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a bulb with bare
hands or a damp cloth. It can also shorten the
bulb life.
To remove:
1
Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass cover
clear the grooves of the socket.
2 Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
To replace:
1
Use a new 130-volt Halogen bulb, not to
exceed 50 watts.
2 Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb
with bare fingers.
3 Push the bulb straight into the receptacle
all the way. Then replace the screen.
NOTE:
The screen must be replaced or
the life of the bulb will be reduced.
4 Place the tabs of the glass cover into the
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
5 Reconnect electrical power to the oven.
Care and Cleaning of the Oven
Trivection ™ Wall Oven
Bulb
Socket
Tab
Glass cover
Screen
Receptacle
Use gloves
or cloth
Receptacle
BE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANY
PART OF THE OVEN.
How to
remove
packaging
tape
To assure no damage is done to the finish
of the product, the safest way to remove the
adhesive left from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent, mineral oil or
cooking oil. Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance polish
to thoroughly clean and protect the surface.
NOTE: The plastic tape must be removed from all
chrome trim. It cannot be removed if it is baked on.