GE 200D26000P022 - Manual (Page 5)

Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
5
About the temperature controls.
www.GEAppliances.com
WARMER COLDER
ADJUST REFRIGERATOR TEMP
9 IS COLDEST
WARMER COLDER
ADJUST FREEZER TEMP
9 IS COLDEST
The temperature controls are preset in the factory at 5 for both the
refrigerator and freezer compartments. Allow 24 hours for the temperature to
stabilize to the preset recommended settings.
Several adjustments may be required. Adjust the controls one increment at a
time, and allow 24 hours after each adjustment for the refrigerator to reach
the setting you have selected.
Setting either or both controls to 0 stops cooling in both the freezer and
refrigerator compartments, but does not shut off electrical power to the
refrigerator.
Control settings will vary based on personal preferences, usage and
operating conditions and may require more than one adjustment.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
About TurboCool ™
(on some models)
.
How it Works
TurboCool rapidly cools the refrigerator
compartment in order to more quickly
cool foods. Use TurboCool when adding a
large amount of food to the refrigerator
compartment, putting away foods after they
have been sitting out at room temperature
or when putting away warm leftovers. It can
also be used if the refrigerator has been
without power for an extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and
off at high speed as needed for eight hours.
The compressor will continue to run until
the refrigerator compartment cools to
approximately 34°F (1°C), then it will cycle
on and off to maintain this setting. After 8
hours, or if TurboCool is pressed again, the
refrigerator compartment will return to
the original setting.
How to Use
Press TurboCool. The TurboCool
indicator light will come on; however,
the refrigerator temperature display
will still show the current setting.
After TurboCool is complete, the TurboCool
indicator light will go out.
NOTES: The refrigerator temperature
cannot be changed during
TurboCool.
The freezer temperature is not
affected during TurboCool.
When opening the refrigerator
door during TurboCool, the fans
will continue to run if they have
cycled on.