Grizzly H7762 - Manual (Page 16)

-14- H7762 Heavy Duty Tool Grinder
Grinding Wheels
The Model H7762 features two Type 50 plate-
mounted grinding wheels that must be attached
to the grinder body before any operation of the
machine.
Components and Hardware Required Qty
Grinder Unit ....................................................... 1
Type 50 Plate-Mounted Grinding Wheels ......... 2
Hex Bolts M6-1 x 25 .......................................... 8
To install the grinding wheels:
1. Remove the rubber shaft end bushing from
the end of the arbor.
2. Carefully slide the grinding wheel onto the
arbor. Be sure not to bump or scratch the
wheel as it may dent, crack or otherwise
damage the wheel.
3. Align the large holes in the grinding wheel
with the large screw holes in the connection
plate of the grinder.
4. Tightly fasten the wheel to the connector
plate using the four hex bolts. In order to
properly balance the wheel, tighten the bolts
in the order shown in
Figure 5.
5. Push the rubber shaft end bushing back onto
the end of the arbor.
6. Repeat Steps 1-6 for the second grinding
wheel.
Figure 5. Wheel bolt mounting order.
Arbor
Grinding
Wheel
1st
Bolt
2nd
Bolt
4th
Bolt
3rd
Bolt
Work Tables
The Model H7762 also features two work tables
that must be installed before any work can com-
mence.
Components and Hardware Required Qty
Grinder Unit ....................................................... 1
Work Table Angle Gauges ................................ 4
Lock Handles M10-1.25 x 23 ............................ 4
Flat Washers 10mm .......................................... 4
Lock Washers 10mm ......................................... 4
Work Tables ...................................................... 2
Flat Washers 8mm ............................................ 4
Hex Nuts M8-1.25 ............................................. 4
To install the work tables:
1. Attach an angle gauges to the grinder body
wih a 10mm washer, 10mm lock washer and
lock handle as shown in
Figure 6.
Figure 6. Attaching angle gauge.