Operation safety, Notice, Operations – Grizzly H2669 User Manual

Page 15

Advertising
background image

H2669 Hobby Lathe

-13-

Using this machine without proper protec-

tive gear could result in damage to your

eyes, lungs, and ears. Always wear safety

glasses, a respirator, and hearing protection

when operating this machine.

Operation Safety

SECTION 4: OPERATIONS

NOTICE

If you have never used this type of machine

or equipment before, WE STRONGLY REC-

OMMEND that you read books, trade maga-

zines, or get formal training before begin-

ning any projects. Regardless of the con-

tent in this section, Grizzly Industrial will

not be held liable for accidents caused by

lack of training.

Tie back long hair, roll

up long sleeves and

remove loose clothing,

jewelry or gloves to

avoid being pulled into

moving parts.

Operations

The Model H2669 Hobby Lathe will perform many
tasks, including spindle and faceplate turning as
well as disc sanding.

This section will guide you through setup for a
typical spindle turning application.

To setup for spindle turning:

1. DISCONNECT THE ELECTRIC DRILL

FROM THE POWER SOURCE.

2. Mark both ends of your workpiece by draw-

ing diagonal lines from corner to corner. The
intersection point of these lines will show you
the center of your workpiece. See

Figure 11

for details.

Note: 24" is the maximum length of stock you
can turn with your hobby lathe and 6" is your
maximum end width.

���������

���������

������

������������

�����������������

��������������

Figure 11. Workpiece marked diagonally across

corners to determine the center.

Advertising