Gefen EXT-HDMI-CAT5-145 - Manual (Page 8)

5
Reset Button 1
Pressing this button will reset the unit and cause the source to re-detect the
EDID. This is useful for when the EDID mode on the rear panel is changed.
Active LED Indicator 2
This LED will become active when a valid link between the 1:5 Splitter For HDMI
Over CAT-5 sender and the source has been established.
Power LED indicator 3
This LED will become active once the included 24V DC power supply has been
properly connected to the sender unit.
RJ-45 Extension Ports 4
There are 2 RJ-45 ports for each of the 4 HDMI extensions to remote locations.
There is one port labeled DDC and once port labeled Video. Both ports must be
used for HDMI extension.
HDMI Jumper Input Port 5
A short jumper cable (included) from the lower HDMI output ports must be
connected to these input ports to use the extension feature. There are 4 input
ports that can be used by up to 4 of the 5 HDMI output ports.
24V DC Power Input 6
Connect the included 24V DC power adapter between this input port and an
available wall power socket.
EDID Mode Switch 7
This switch will determine which EDID mode is used. The two modes are
Internal EDID and External EDID. Please see page 9 for information on how this
feature is used.
HDMI Input Port 8
Connect the HDMI source device to this input port. The HDMI signal that is
connected to this input port will be mirrored to the 5 output ports on the rear
panel.
HDMI Output Ports 9
There are 5 HDMI output ports that are available for connection to either the
extension jumper inputs (up to 4 outputs) or to local HDMI capable displays.
SENDER PANEL DESCRIPTIONS