GE Profile 465 - Manual (Page 8)

Automatic Cycle
Signal
8
Operating Instructions
Safety Instructions
Customer Service
Troubleshooting T
ips
About your dryer features.
End of Cycle Signal
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models, the signal sound
level can be adjusted.
If you selected the WRINKLE CARE option
the signal will sound at the end of the
drying time and will sound several times
during the WRINKLE CARE cycle. This will
remind you that it is time to remove the
clothes.
NOTE:
■ Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won’t set in.
■ Use the END OF CYCLE SIGNAL especially
when drying fabrics like polyester knits
and permanent press. These fabrics should
be removed so wrinkles won’t set in.
Drum Lamp
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and
replace with the same size bulb.
Wrinkle Care
Use this option to minimize the wrinkles
in clothes. It provides approximately 15
minutes of no-heat tumbling after the
clothes are dry.
This option can only be used with the
COTTONS, EASY CARE, DELICATES, and
ULTRACARE cycles. If you are using the CYCLE
SIGNAL and you select the WRINKLE CARE
option, a signal will sound at the end of the
drying time and several times during the
WRINKLE CARE cycle. This will remind you
that it is time to remove the clothes.
If WRINKLE CARE is not ON, the dryer will stop
once the timer reaches the WRINKLE CARE
mark on the cycle dial.
Dryness Sensor Cycle–on some models
This feature is only activated in the
COTTONS, EASY CARE, DELICATES, and
ULTRACARE cycles.
The Dryness Sensor provides greater
drying accuracy than standard machines,
resulting in shorter dry times and better
clothes care. As the clothes tumble, they
touch a moisture sensor. The sensor will
stop the heating cycle as soon as the clothes
have reached the selected dryness.
On some models, there is a Dryness
Sensor Cycle indicator light. This light is
illuminated during automatic cycles.
When the Dryness Sensor feature stops the
heating cycle, the light will go out and the
cool down period will begin.
Note: The clothes will be hot if they are
removed immediately after the indicator
light goes out.
Dryness
Sensor Cycle
Color Logic
Select the correct FABRIC CARE setting. Match
the particular color below the words with the
same color on the Cycle Dial.
Example: Drying a load of clothing labeled
permanent press.
Choose the FABRIC CARE setting-—for this
load it would be the EASY CARE MED.
HEAT (which is a particular color).
Turn the Cycle Dial to the area that has
the same color as the FABRIC CARE setting
you have chosen—for this load it would be
the EASY CARE AUTOMATIC. 2
1
(appearance may vary)
Automatic Cycle Signal–on some models
At the end of each cycle there is
approximately 15 minutes of no-heat
tumbling after the laundry is dry. A reminder signal will sound periodically
during this time to remind you to remove the
laundry.