Grizzly H3236 - Manual

MODEL H3236
SLOW SPEED KIT
For G4176
INSTRUCTIONS
4. Remove the chain cover and the two 14mm
hex nuts securing the Position A & B change
gears to the shafts.
5. Swap the required gears in Positions A & B
shown in Figure 2.
6. Reinstall the hex nuts and the chain cover.
The Model G4176 power feeder is equipped with
two sets of change gears that provide four different
feed rates of 20, 26, 33, and 43 feet per minute.
The Model H3236 Slow Speed Kit provides
two additional feed rates of 13 and 62 feet per
minute. Use the table below (
Figure 1) and these
instructions to install the required change gears to
get your desired feed rate.
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
Figure 2. Change gear locations.
Change Gear
Position A
Change Gear
Position B
Change Gear
Chart
To change your power feeder feed rate:
1. Move the switch to the OFF position.
2. DISCONNECT THE POWER FEEDER
FROM POWER!
3. Refer to the change gear table on the inside
of the chain cover ( Figure 2) or the table
in Figure 1 to find the gear combination
required for your chosen feed rate.
If you need help with your new item, call our Tech
Support at: (570) 546-9663.
COPyRIGHT © JULy, 2008 By GRIzzLy INDUSTRIaL, INC.
WARNING: NO PORTION OF THESE INSTRUCTIONS MAy BE REPRODUCED IN ANy SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLy INDUSTRIAL, INC.
#CR10849 PRINTED IN TaIWaN
Model H3236 Slow Speed Kit Gears:
A, 16 Tooth + B, 34 Tooth = 13 Ft (4M)/
Per Min
A, 34 Tooth + B, 16 Tooth = 62 Ft (19M)/
Per Min
Original Equipment Change Gears:
A, 20 Tooth + B, 30 Tooth = 20 Ft (6M)/
Per Min
A, 30 Tooth + B, 20 Tooth = 43 Ft (13M)/
Per Min
Original Equipment accessory Change Gears:
A, 24 Tooth + B, 26 Tooth = 26 Ft (8M)/
Per Min
A, 26 Tooth + B, 24 Tooth = 33 Ft (10M)/
Per Min
Change Gear and Feed Rate Chart
Figure 1. Change gear table.