Generac 004451 - Manual (Page 7)

5
1.2.3 BATTERY CONNECTION
• The battery shipped with the generator has been provided fully
charged. Caution must be taken when connecting the battery.
• Cut the tie wrap cable holding the RED and BLACK battery cables
to the stator.
• Connect the RED battery cable to the battery Positive terminal (+).
After making sure that the connection is tight, slip the rubber boot
over the terminal connection.
• Connect the BLACK battery cable to the battery Negative terminal
(–). Make sure the connection is tight.
• Double check all connections to ensure they are in the correct
location and secure. See Figure 3 at right.
Figure 3 - Battery Connections
FLAT WASHER
LOCK WASHER
LOCK NUT
FLAT WASHER
HANDLE
FLAT WASHER
CAPSCREW,
5/16 X 2-1/2
ASSEMBLY
FRONT FOOT
LOCK
NUT
LOCK NUT
LOCK WASHER
FLAT WASHER
CAPSCREW, 5/16 X 1
CARRIAGE BOLT, 3/8 X 1
SPACER
AXLE
RETAINING PIN
WHEEL
Section 1 - General Information
Commercial-Industrial-Residential Portable Generator System
Negative
Cable
Positive
Cable
Figure 2 - Handle Assembly