GE 25 and 27 - Manual (Page 5)

TurboCool rapidly cools the refrigerator
compartment in order to more quickly
cool foods. Use TurboCool when adding a
large amount of food to the refrigerator
compartment, putting away foods after they
have been sitting out at room temperature
or when putting away warm leftovers. It can
also be used if the refrigerator has been
without power for an extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and
off at high speed as needed for eight hours.
The compressor will continue to run until
the refrigerator compartment cools to
approximately 34°F (1°C), then it will cycle
on and off to maintain this setting. After 8
hours, or if TurboCool is pressed again, the
refrigerator compartment will return to
the original setting.
How to Use
Press TurboCool. The TurboCool
indicator light will come on; however,
the refrigerator temperature display
will still show the current setting.
After TurboCool is complete, the TurboCool
indicator light will go out.
NOTES: The refrigerator temperature
cannot be changed during
TurboCool.
The freezer temperature is not
affected during TurboCool.
When opening the refrigerator
door during TurboCool, the fans
will continue to run if they have
cycled on.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
5
About the temperature controls.
ge.com
WARMER COLDER
ADJUST REFRIGERATOR TEMP
9 IS COLDEST
WARMER COLDER
ADJUST FREEZER TEMP
9 IS COLDEST
Initially, set the refrigerator control at 5 and the freezer control at 5 and allow 12–24
hours for the temperature to stabilize.
Several adjustments may be required. Adjust the controls one increment at a time, and
allow 12 hours after each adjustment for the refrigerator to reach the temperature you
have set.
Setting the controls to 0 stops cooling in both the refrigerator and freezer compartments
but does not shut off electrical power to the refrigerator. On some models, only the
refrigerator control has a 0 setting.
Touch pad controls
• Setting either control at 0 will automatically set the other control at 0. The zeros will
blink until you set the controls.
• If both controls are set at 0 and either COLDER pad is pressed, the controls will
automatically reset to 5.
Control settings will vary based on personal preferences, usage and operating
conditions and may require more than one adjustment.
NOTE: On some models, the refrigerator is shipped with protective film covering the temperature
controls. If this film was not removed during installation, remove it now.
About TurboCool. ™
(on some models)
How it Works