Installation of the warming drawer, Installation below wall ovens, Installation below a single oven – GE JTD910SBSS User Manual
Page 14: Installation below a double oven, Read these instructions completely and carefully
Installation of the warming drawer.
Read these instructions completely and carefully.
Installation Below Wall Ovens
■
When installed, the front face of the warming
drawer will be nearly flush with cabinetry doors
or drawer fronts.
■
Drawer overlaps will conceal cut edges on all
sides of the opening.
The rough opening for the drawer must be:
—Depth: 23
1
⁄
2
″
minimum from inside back to
front of cabinet frame.
—Width: 25
1
⁄
2
″
for 27
″
wide models
28
1
⁄
2
″
for 30
″
wide models.
—Height: 9
1
⁄
4
″
—Allow 2
″
minimum between oven and drawer
cutouts for clearance of overlaps.
NOTE: If you are installing in frameless cabinets,
it may be necessary to install 1/2
″
wide cleats to
accept drawer mounting screws. See drawer to
find exact locations of mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation
below only certain specified wall oven models.
See the label attached to the top of the warming
drawer for suitable models.
NOTE: Electrical receptacle can be installed
as shown for countertop installations. Do not
install receptacle above the top of the warming
drawer cutout.
23
1
⁄
2
″
Min.
2x2 or 2x4 anti-tip
block against rear
wall 9” from floor
to bottom of block
1
″
Min. above toekick or adjust
to oven installation height
A
B
Oven
cutout
NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
⁄
2
″
depth and 9
1
⁄
4
″
height.
Installation below a single oven
2
″
Min
1
″
Min. above toekick
NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
⁄
2
″
depth and 9
1
⁄
4
″
height.
Installation below a double oven
Dimension A
Dimension B
27
″
Drawer
25
1
⁄
2
″
26
3
⁄
4
″
30
″
Drawer
28
1
⁄
2
″
30
″
2x2 or 2x4 anti-tip
block against rear
wall 9” from floor
to bottom of block
9
″
2
″
Min.
Allow 5/8”
overlap on
all sides
10
1
⁄
2
″
23
1
⁄
2
″
Min.
Allow 5/8
″
overlap
on all sides
A
Oven
cutout
23
1
⁄
4
″
10
1
⁄
2
″
B
9
″
9
1
⁄
4
″
23
1
⁄
4
″
9
1
⁄
4
″
Customer Service
Troubleshooting T
ips
Installation Instructions
Care and Cleaning
Operating Instructions
Safety Instructions
14