GE PNRQ20FRI - Manual (Page 12)

Installation Instructions
12
TUBING AND FLOW RESTRICTOR INSTALLATION
INSTALLING THE TUBING TO TANK
AND FAUCET
1. Measure 3/4
″ from the end of each
remaining piece of tubing (faucet end and
inlet end) and mark with a pencil. (Check
for roundness, smoothness, cuts, nicks,
flat spots and sharp edges).
2. Push the tubing firmly into each fitting on
the manifold until the line is flush with the
fitting collar. (If the tubing is removed, re-
cut the end, measure, mark and re-insert).
Tubing must be fully inserted to avoid
leaks. To remove tubing: depress and hold
red or blue collet; pull tubing out to remove.
3. Pull out slightly on tubing to ensure a
good seal.