Grizzly T10007 - Manual (Page 10)

Model T10007 300 Kg Digital Crane Scale -9 -
Reference Guide
Display Action
- - - - - Wait signal
Err10 Accumulated weight below capacity
Err11 Accumulated times exceed (30+)
Err12 Accumulated weight exced (999.99)
CLr Delete weight?
noCLr Cancel deletion
88888 Confirm deletion
noACC No accumulated value
SHIFt Weight conversion
UX.XX Current battery voltage
SCALE Enter weight adjustment
SEtUP Enter parameter adjustment
UAdJ Enter voltage adjustment
-OL- Overload warning
-Lb- Low battery warning
End Parameter adjustment ready
OFF Turn off
Function Button Display Action
ON 8.8.8.8.8
661.4
U X.XX
- - - - -
0.0 Scale is ready for use
OFF OFF/ U X.XX
OFF Scale is OFF
Zero 0.0 Display reads 0, "Zero" LED is on
Tare TARE/ 0.0 Display reads 0, Tare LED is on
Hold HOLD XXXX.X Weight is held, press HOLD to exit
Brightness F1 1 through 5 1=lowest, 5=highet setting
Note: The remote control is a generic
remote and may contain buttons that will
not be used with this particular model.
Should you lose the included remote con-
trol, the remote control functions cannot be
completed. To obtain a replacement con-
troller from Grizzly; call 1-800-523-4777.
For quick references and questions about
scale displays, use these reference charts
for assistance.
Function Button Display Button Action
Lb/Kg Conversion MR SHIFT HOLD UN=O (weight in Kg, "lb" LED is off)
UN=1 (weight in Lb, "lb" LED is on)
Battery Voltage MR SHIFT F1 U X.XX, press MR to exit
Current Zero Value MR SHIFT / XXXX.X Current zero value
Advance Tare MR SHIFT TARE/ TARE to scroll right
to increase number
CLEAR to decrease number
M+ to submit and scroll left
MR to submit total, "TARE" LED is on
Overload Review MR SHIFT CLEAR OL=XX (Overload= XX times)
Clear CLEAR CLR MR 888.88 = confimation of clear
CLEAR noCLR = cancel clear
�
�