GE 15 - Manual (Page 18)

18
Installation Instructions
Tighten any connections that leak.
TURN THE WATER ON AT THE
SHUTOFF VALVE 10
INSTALLING THE WATER LINE
(CONT.)
1
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall. Push the refrigerator back to the wall.
PLUG IN THE REFRIGERATOR 11
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F
(–9°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON position.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
START THE ICEMAKER 12
REVERSING THE DOOR SWING
2
Power
switch
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
IMPORTANT NOTES
Phillips screwdriver
TOOLS REQUIRED
Masking tape
T20 or T25
Torxdriver,
whichever your
model requires 5/16 ″ hex-head
socket driver
5/16 ″ open-end
wrench
Putty knife or thin-
blade screwdriver