Grizzly 7" Angle Polisher H0593 - Manual

Introduction
This versatile 7" Angle Polisher is a mate to our
H0592 7" Angle Sander. Requires 90 PSI and
consumes 12 CFM. The spindle thread is
5 ⁄
8
" x 11
UNC and no load speed is 2,500 RPM. Weighs 5
lbs. Air inlet size is
1 ⁄
4
" NPT.
Inventory
A. Air Polisher ................................................. 1
B. Pin-Type Spanner Wrench ......................... 1
C. Flat Wrench 19mm ..................................... 1
D. 7” Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F. Handle ........................................................ 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in
Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in
Figure 3.
MODEL H0593
7" ANGLE POLISHER
INSTRUCTION SHEET
Figure 1. Model H0593.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPyRIgHT © FEbRUARy, 2006 by gRIzzLy INdUSTRIAL, INC. REvISEd SEPTEMbER, 2009 (bL)
WARNING: NO PORTION OF THIS MANUAL MAy BE REPRODUCED IN ANy SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLy INDUSTRIAL, INC.
#TR7990 PRINTEd IN TAIWAN
EyE INJURy HAzARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURy HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAzARD!
Never exceed 120 PSI.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Installing your tool.