GE WA9895S - Manual (Page 6)

HOW TO OPERATE YOUR CLOTHES WASHER
Features and appearances may vary slightly
WARNING—To reduce the risk of fire, electric shock, or injury to persons when using your
appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
SIZE SPOTSCRUBBER
Setting the Controls
Use the Suggested Fabric and Cycle Settings
guide to help you make the proper selections.
Select an automatic Fabric Care Program
OR customize a Fabric Care Program
●
To use the automatic Fabric Care Programs, select
one of the following:
Choose desired For these Set Matching For these
Fabric Care Cycle Selection
Selection Temperatures Dial)
Cottons Colorfast Hot/Cold Cottons, Regular NormalFast
Cottons Non-Colorfast Cold/Cold Cottons, Regular
Permanent Press-Knits Permanent Press Normal/Slow
& Knits
Silks Cold/cold
Gentle/Slow
Woolens *War Gentle/Slow
*’, ;,\
●
To customize a Fabric Care Program.
The automatic Fabric Care Program is programmed
for the majority of laundry you will wash. Customizing
your washer to your specific needs is easy.
For example: You want to wash a load of clothes at
warm wash, cold rinse, normal wash speed and fast spin
speed. To do that, simply press the Permanent Press-
Knits pad (for the warm wash and cold rinse) and set the
Cycle Selector knob at Normal on the Cottons, Regular
cycle (for Normal Wash Speed and Fast Spin Speed).
COTTONS,
OFF PERMANENT PRESS
● # KNITS
d
LIGHT SOIL OFF
NORMAL
SPOTSCRUBBER O FF ● OFF
‘REWASH
Select Water Level.
SMALL: Washer is less than 1/3 full of clothes.
MEDIUM: Between 1/3 and 1/2
LARGE: Between 1/2 and 2/3
EXTRA LARGE: Over 2/3 full.
MINI-BASKET: Not used for regular loads. See How
to Use the Mini-Basket Tub section.
If you wish to increase the water level after you’ve
made a selection, turn knob to RESET and select
new
Select Cold Wash if desired, this option
will cancel the wash temp. in the Fabric Care
Selections.
Select Extra Rinse, if desired. Pressing pad will
provide a second deep rinse with Spotscrubber,
Cottons and Regular, or Permanent Press and
Knits cycles. Press the Reset pad to cancel
selection.
End Cycle Signal. Select this signal to remind
you to remove clothes from the washer when the
cycle ends. Signal will sound and then stop. See
the End Cycle Signal section.
The Reset Options pad will allow you to cancel
a selected Option.
Select SPOTSCRUBBER, if desired. See
How to Use the SPOTSCRUBBER Cycle
for Removing Stains section.
Push Cycle Selector knob in and turn clockwise
to your selected wash setting.
Pull Cycle Selector knob out ‘TART
to start the washer. If you wish
to change setting after washer
has started, push Cycle Selector
\
STOP
6
knob into the-washer and reset to the
new position. Setting can be changed at any time.