Graco Inc. 244592 User Manual
Auto xs aa, Instructions/parts list
Advertising
Instructions/Parts List
AUTOMATIC ELECTROSTATIC AIR-ASSISTED SPRAY GUN
PRO
™
Auto Xs AA
TI1713A
309298J
ENG
Part No. 244592, Series A
100 psi (0.7 MPa, 7 bar) Maximum Air Inlet Pressure
3000 psi (21 MPa, 210 bar) Maximum Working Fluid Pressure
For use in Class I, Div. I hazardous locations using Group D spray materials.
For use in Group II, Zone 1 areas using Group IIA spray materials.
For Professional Use ONLY.
U.S. Patent 7,226,004
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
See page 2 for Table of Contents.
#
53
II 2 G EEx 0.24MJ
Advertising
Table of contents
Document Outline
- Symbols
- Warning
- Introduction
- Installation
- Install the System
- Warning Signs
- Ventilate the Spray Booth
- Install the Air Line Accessories
- Install the Fluid Line Accessories
- Install the Gun and Mounting Bracket
- Connect the Air and Fluid Lines
- Manifold Connections
- Optional Fiber Optic Cable Connection
- Grounding
- Check Electrical Grounding
- Check Fluid Resistivity
- Check Fluid Viscosity
- Install the Fabric Cover
- Operation
- Maintenance
- Electrical Tests
- Troubleshooting
- Repair
- Prepare the Gun for Service
- Remove the Gun from the Manifold
- Install the Gun on the Manifold
- Tip Guard, Air Cap, Spray Tip, or Seat Housing Replacement
- Electrode Replacement
- Fluid Tube Replacement
- Fluid Filter Removal
- Fluid Needle Replacement
- Piston Repair
- Adjust the Actuator Arm
- Barrel Removal
- Barrel Installation
- Power Supply Removal and Replacement
- Turbine Alternator Removal and Replacement
- Parts
- Spray Tip Selection Chart
- Accessories
- Technical Data
- Graco Standard Warranty
- Graco Information