Grizzly Extreme-Duty s G9740 - Manual (Page 5)

extreme duty planers -3-
9. use proper extension cord. make
sure your extension cord is in good condi-
tion. Conductor size should be in accor-
dance with the chart below. the amperage
rating should be listed on the motor or tool
nameplate. an undersized cord will cause
a drop in line voltage resulting in loss of
power and overheating. your extension
cord must also contain a ground wire and
plug pin. always repair or replace exten-
sion cords if they become damaged.
minimum gauge for extension Cords
10. Wear proper apparel. do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. non-slip footwear
is recommended. Wear protective hair cov-
ering to contain long hair.
11. alWays use safety glasses. also
use face or dust mask if cutting operation
is dusty. everyday eyeglasses only have
impact resistant lenses, they are not
safety glasses.
12. secure WorK. use clamps or a vise to
hold work when practical. it is safer than
using your hand and frees both hands to
operate tool.
13. never overreach. Keep proper foot-
ing and balance at all times.
length
amp rating 25ft 50ft 100ft
0-6 16 16 16
7-10 16 16 14
11-12 16 16 14
13-16 14 12 12
17-20 12 12 10
21-30 10 10 no
safety instructions for power tools
14. maintain tools With care. Keep
tools sharp and clean for best and safest
performance. Follow instructions for lubri-
cating and changing accessories.
15. disconnect tools before servicing
and changing accessories, such as blades,
bits, cutters, and the like.
16. reduce the risK of unintentional
starting. make sure switch is in OFF
position before plugging in.
17. use recommended accessories.
Consult the owner’s manual for recom-
mended accessories. the use of improper
accessories may cause risk of injury.
18. checK damaged parts. before fur-
ther use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended func-
tion. Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that
may affect its operation. a guard or other
part that is damaged should be properly
repaired or replaced.
19. never leave tool running
unattended. turn poWer OFF. do
not leave tool until it comes to a complete
stop.
20. never use under the influence of
alcohol or drugs, or when tired.
21. never alloW unsupervised or
untrained personnel to operate
the machine. make sure any instruc-
tions you give in regards to the operation
of the machine are approved, correct, safe,
and clearly understood.