Grizzly T20644 - Manual (Page 11)

T20644 34° Angle Finish Nailer–2½" -10 -
OPERATIONS
Loading
When replacing nails in your Model
T20644, follow these guidelines:
Gauge: ................................................... 15
Length:........................................ 1
1 ⁄
4
" -2 1 ⁄
2
"
Capacity: ................................................ 80
Angle: ...................................................34°
Note: A number of manufacturers' nails
may fit the Model T20644. However, for
best performance, we recommend you use
the following Grizzly nails:
G6085-G6088, G9545, G6090, G3693-
G3697.
3. Slide the nail stick all the way down to
the nose of the nailer.
4. Pull the magazine pusher all the way
back, then let it come forward until it
rests against the end of the nail stick.
Figure 3. Loading finish nails into nailer.
Pusher
Release
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Insert a nail stick into the T-slot at the
top of the magazine as shown in Figure
3.