Using the dishwasher, Using the dishwasher , 9, Dish preparation prior to loading – GE EDW5000 User Manual

Page 8: Or cascade crystal clear, Rinse agent

Advertising
background image

Dish Preparation Prior to Loading

■ No pre-rinsing of normal food soil is required.
■ Scrape off hard soils, including bones,

toothpicks, skins and seeds.

■ Remove large quantities of any remaining

food.

■ Remove leafy vegetables, meat trimmings

and excessive amounts of grease or oil.

■ Remove acidic food soils that can discolor

stainless steel.

8

Operating

Instructions

Safety

Instructions

Consumer

S

uppor

t

Tr

oubleshooting

Tips

Using the dishwasher.

Check the Water Temperature

Use Jet-Dry

®

or Cascade Crystal Clear

®

Rinse Agent

Jet-Dry

®

or Cascade Crystal Clear

®

rinse agents remove spots and prevent new film buildup on

your dishes, glasses, flatware, cookware and plastic.

Filling the Dispenser

The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal
conditions, this will last approximately one month. Refill when rinse agent
is not visible in the indicator. Do not overfill.

Make sure the dishwasher door is fully open.

Turn the dispenser cap to the left and lift it out.

Add rinse agent until the indicator window looks full. Do not overfill.

Clean up any spilled rinse agent with a damp cloth to prevent foam.

Replace the dispenser cap.

Rinse Aid Setting

The amount of rinse agent released into the final wash can be
adjusted. The factory setting is at the midpoint. If there are rings of
calcium (hard water) spots on dishes, try a higher setting. If you
observe foam in the final rinse, try a lower setting.

To adjust the setting
Remove the dispenser cap, then turn the adjustable setting dial
counterclockwise to increase the amount of rinse agent or clockwise
to reduce the amount of rinse agent dispensed.

5

4

3

2

1

The entering water should be at least 120°F and
not more than 150°F, for effective cleaning and to
prevent dish damage. Check the water temperature
with a candy or meat thermometer. Turn on the hot

water faucet nearest the dishwasher, place the
thermometer in a glass and let the water run
continuously into the glass until the temperature
stops rising.

M

in

M

ax

Indicator

Dispenser cap

Adjustable setting dial

Advertising