GE JDP39 - Manual (Page 7)

7
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
ge.com
Oven Control, Clock and Timer Features and Settings
AUTOMATIC OVEN Light
This lights anytime the oven has been
programmed using the COOKING TIME or
DELAY START functions.
– Pad
Short taps to this pad will decrease the time
or temperature by small amounts. Touch
and hold the pad to decrease the time or
temperature by larger amounts.
+ Pad
Short taps to this pad will increase the time
or temperature by small amounts. Touch
and hold the pad to increase the time or
temperature by larger amounts.
SELF CLEAN Pad
Touch this pad to select the self-cleaning
function. See the Using the self-cleaning
oven section.
CLEAN Light
Flashes while in edit mode—you can change
the length of time for the self-clean cycle at
this point. Glows when the oven is in the self-
clean cycle. After the self-clean cycle, the light
will turn off. Unlatch the door.
CLEAR/OFF Pad
Touch this pad to cancel ALL oven
operations except the clock and timer.
BROIL HI/LO Pad
Touch this pad to select the broil function.
BROIL Light
Flashes while in edit mode—you can switch
from HI to LO BROIL at this point. Glows when
the oven is in broil mode.
Indicator Lights (on some pads)
EDIT mode lasts several seconds after the
last pad press. DELAY START ON/OFF and
COOKING TIME ON/OFF will be the only pads
lit if either of these options is selected.
(Example: DELAY START is selected with
BAKE—the DELAY START pad will remain
lit until the clock reaches the programmed
time, at which point it will turn off and the
BAKE/TEMP RECALL pad light will light up).
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock. To reset the clock, touch the CLOCK pad.
Enter the correct time of day by touching
the + or – pads. Touch the START/ON pad.
Control Lockout
Your control will allow you to lock out the touch
pads so they cannot be activated when touched.
To lock/unlock the controls:
Touch the + and – pads at the same
time for 3 seconds, until the display
shows LOC ON.
To unlock the control, touch the +
and – pads at the same time for 3
seconds, until the display shows
LOC OFF.
When this feature is on and the touch
pads are touched, the control will beep
and the display will show LOC ON.
■
The control lockout mode affects all
touch pads. No touch pads will work
when this feature is activated.
■
The adjustment will be retained in
memory after a power failure.
CONTROL LOCK/UNLOCK
PRESS + AND – AND HOLD FOR 3 SECONDS