Grizzly 60' Range Finder H5844 - Manual (Page 2)

CLEARING DISPLAY & CLEARING
STORED MEASUREMENTS
The ALL MEMORY CLEAR button has two
functions, depending on how long the button is
pressed.
To clear the display , press the ALL MEMORY
CLEAR button briefly.
To clear all stored measurements from the
memory
, press and hold the ALL MEMORY
CLEAR button for five seconds.
CALCULATING VOLUME
The range finder multiplies three stored
measurements to quickly calculate a given
volume.
To calculate the volume , store the length,
height, and width in all three of the M # buttons.
Press the VOL (volume) button and the range
finder will automatically calculate the volume from
the three measurements stored in the M
#
buttons.
CALCULATING AREA
The range finder multiplies two stored
measurements to quickly calculate the square
feet or square meters of a given area.
To determine the area , store the length and
width in any of the three M # buttons. Press the
AREA button, then press the two M # buttons
where the length and width are stored.
M #
M # M #
+ +
M # M #
– –
AREA M # M #
VOL
ALL
MEMORY
CLEAR
ADDITION/SUBTRACTION
The range finder can add or subtract
measurements that are stored in the memory with
currently displayed measurements or other stored
measurements.
To add (or subtract) two stored
measurements
, recall the first measurement by
pressing the appropriate M # button, then press
the “+” (or “-”) button, then recall the next
measurement by pressing the other appropriate
M
# button, then press the “+” (or “-”) key to show
the total of the added (subtracted) measurements.
STORING & RECALLING
MEASUREMENTS
The range finder can store and recall
measurements for the purpose of making
calculations.
To store a measurement , take the
measurement, press the STORE button, then
press one of the M
# buttons (M1, M2, M3).
To recall a stored number, press the M # button
that corresponds to the stored measurement you
want to recall.
STORE M # MEASURE
MEASURING DISTANCES
The range finder measures from the back end of
its case to the object at which it is pointed (see
illustration on previous page).
To take a measurement , position the back end
of the range finder against the starting point and
press the MEASURE button.
The range finder will beep once to acknowledge
the button was pressed, then beep twice and
display the measurement. Note—
The range
finder works best when measuring surfaces at
least 11
3 ⁄
4
" (30 cm) wide.
MEASURE
If you need additional help with this item, call our
service department at: (570) 546-9663.