GE ZET2S - Manual (Page 26)

26
Self-Cleaning Oven
Wall Oven
Before a
clean cycle The oven door must be closed and all controls
must be set correctly for the self-clean cycle to
work properly.
We recommend venting your kitchen with
an open window or using a ventilation fan
or hood during the first self-clean cycle.
• Clean soil from the frame around the oven
door and outside the door gasket. These
areas must be cleaned by hand.
• Do not clean the door gasket by hand as this
could damage it.
• Wipe up excess grease and other food spills
with a damp cloth. This will minimize the
amount of smoke created during self-
cleaning.
• Remove all cookware, broiler pan, grid, probe
and any aluminum foil from the oven.
• The oven racks may be left in the oven during
the self-clean cycle.
• Make sure the oven light lens and lens frame
are in place.
• Do not use commercial oven cleaners,
abrasives or oven protectors in or near the
self-cleaning oven.
IMPORTANT: The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any oven.
Move birds to another well-ventilated room.
NOTE: Self-Clean will not work if the
temperature probe is plugged in or if the
Sabbath feature is set.
On double oven models, you can set a clean cycle
in both ovens at the same time. The last oven set will
automatically delay its start until the end of the first
oven’s clean cycle.
On double oven models, you can use timed baking in
one oven and self-clean in the other at the same time.
Turn the Oven Mode knob to CLEAN.
Turn the Temperature knob to CLEAN.
The oven is set to clean for its normal clean
time of 5 hours. (If a clean time less than
5 hours is needed, turn the Mini-Knob to
the clean time desired.) Push to enter it.
You can change the clean time to any
time between 3 and 5 hours, in 15 minute
increments, depending on the amount of soil
in your oven.
NOTE: The Mini-Knob must be pushed for the
self-clean cycle to start.
If your oven is connected to a 208V electrical
supply, we recommend that you set your clean
time for 5 hours.
If LOCKED flashes in the display, the self-clean
cycle has been selected but the door is not
closed. Close the oven door.
The display will show CLEAN and the clean
time remaining.
As the oven heats to the clean temperature,
the door will lock automatically. The LOCKED
light will turn on. The display will show the
clean time remaining. It will not be possible
to open the oven door until the temperature
drops below the lock temperature and the
LOCKED light goes off.
After the clean cycle is complete and
the oven has cooled, END will show in the
display and the LOCKED light will turn
off. Turn the Oven Mode knob and the
Temperature knob to OFF.
To stop a clean cycle, turn the Oven
Mode knob and the Temperature knob
to OFF. When the LOCKED light goes off,
indicating the oven has cooled below the
locking temperature, you will be able
to open the door.
How to set
the oven for
cleaning
Oven Mode knob Temperature knob
Mini-Knob
Turn to select
Push to enter
Double oven display shown.