GE 29878 - Manual (Page 13)

13
S
ETTING THE
S
ECURITY
C
ODE
This setting allows to change the factory default security code used to
access your answerer from a remote location. The default code is 123.
1. The unit announces, “Security code (the current 3 number Security Code
setting). To set security code, press next...press set to stop.”
2. If you press and release the STOP/SET button, the unit announces all the
new settings and exit the set up menu.
3. If you press and release NEXT or PREVIOUS button, unit announces
“Security Code (current 3 number). To set security code, press next,
press set to continue”.
4. To change the first security code number, press and release the NEXT or
PREVIOUS button again. The unit announces all three numbers, but only
the first number will change, such as “123, 223,” or “123, 023”.
5. After choosing the first number, press and release the STOP/SET button
to store the first number.
6. The unit automatically advances to the second number and announces
“Security Code (current 3 number). To set security code, press NEXT
then press SET to continue.” To change the second and third numbers,
repeat steps 4 and 5. After the third number is stored, the unit
announces all the stored settings and exits the setup menu.