Grizzly H5627 - Manual (Page 9)

H5626/H5627 Upholstery Stapler -8 -
Clearing Jammed Staples
A jammed staple must be cleared before
using the stapler again.
To clear a jammed staple:
1. Disconnect the stapler from the air
supply!
2 . Open the magazine cover and pull the
magazine all the way back.
3. Remove stick of staples.
4. Remove jammed staple with needle
nose pliers.
Speed Adjustment
The Model H5627 features staple firing
speeds from .5 to 16 staples per second.
To adjust the staple firing speed:
1. Disconnect the stapler from the air
supply!
2 . Release the speed adjustment lock by
holding the speed adjustment screw
in place with a screwdriver while rotat-
ing the speed adjustment lock counter
clockwise.
3 . Rotate the speed adjustment screw
counter clockwise to increase the fir-
ing speed or clockwise to slow the fir-
ing speed (
Figure 5 ).
4. To test fire the stapler push the sta-
pler against a scrap of wood, hold the
trigger down continuously, and move
the stapler across the wood.
5. When the firing speed has been
adjusted, secure the speed adjust-
ment screw by placing a flat head
screwdriver in the slot and twisting the
speed adjustment lock clockwise until
tight.
Always disconnect air from stapler
whenever clearing a jammed staple!
Fast
Slow
Figure 5. H5627 speed adjustment screw.
Speed
Adjustment
Lock
Speed
Adjustment
Screw