GE NetworX NX-7002 - Manual (Page 9)

Once the data is programmed, press the [*] key to enter the data and advance to the next
segment of that location. After the last segment of a location is programmed, pressing the [*]
key will exit that location, turn the “Ready” LED off and the “Armed” LED on. As before, you are
now ready to enter another programming location. If an attempt is made to program a
number too large for a particular segment, the keypad sounder will emit a triple beep,
indicating an error, and remain in that segment awaiting a valid entry.
Remark: The number in the location will be displayed on the LCD keypad. For locations with a
maximum of 15, the hexadecimal equivalent will be displayed in parenthesis.
Example: 11 (B) or 14 (E).
FEATURE SELECTION DATA
Feature selection data will display the current condition (on or off) of eight features associated
with the programming location and segment selected. Pressing a button on the keypad (1
through 8) that corresponds to the “feature number” within a segment will toggle (on/off) that
feature. Pressing any numeric key between [1] and [8] for selection of a feature will make the
corresponding LED illuminate (feature ON). Press the number again, and the LED will
extinguish (feature OFF). You will see that numerous features can be selected from within one
segment. For instance, if all eight features of a segment are desired, pressing [1] - [2] - [3] - [4]
- [5] - [6] - [7] - [8] will turn on LED’s 1 through 8 as you press the keys, indicating that those
features are enabled.
LCD keypad users note: The numbers of the enabled features will be displayed. However, the
features not enabled will display a hyphen (-).
After the desired setting of features is selected for this segment, press the [*] key. This will
enter the data and automatically advance to the next segment of the location. When you are
in the last segment of a location and press the [*] to enter the data, you will exit that location.
This will now turn the “Ready” LED off and the “Armed” LED on. As before, you are now ready
to enter another programming location.
NX-7002 Installation manual Page 9 09/02/05