Grizzly T10131 - Manual (Page 2)

-2-
t10131 Bandsaw extension table
figure 4. Masking tape location for adjusting the
extension wing down.
figure 3. Masking tape location for tilting the
extension table up.
3. Use a straightedge as a gauge and adjust the
extension wing up/down until it is flush with
the main table above each cap screw, then
completely tighten the cap screws.
4. place the straightedge across the extension
wing and main table to make sure that the
combined table surface is flat.
— if the outside end of the extension wing
tilts down, use a strip of masking tape
along the bottom edge of the main table
to shim the extension wing up (see
figure
3 ).
— if the outside end of the extension wing
tilts up, use a strip of masking tape along
the top edge of the main table to shim the
extension wing down (see
figure 4 ).
Note: After reinstalling the wing, remove
all excess masking tape with a razor
blade.
5. Align the mounting holes on the support plate
and the bottom of the extension table, then
fasten with four M8-1.25 x 12 hex bolts and
flat washers, as shown in
figure 5.
figure 5. Support installed.
4x
6. loosen the knob, slide the lower section of
the support down and tilt the foot so it is flush
with the floor, then tighten the knob.
If you need help with your new extension table,
call our Tech Support at: (570) 546-9663.
g2544—Solvent Cleaner & Degreaser
A great product for removing the waxy shipping
grease from your machine during clean up.
figure 6. Cleaner/degreaser available from
grizzly.
Accessories
Support
plate
Foot
Knob
Do not place workpieces heavier than 100
lbs. on this extension table! Doing so may
cause the table to fail, increasing your risk
of serious personal injury.