Grizzly 5 GALLON AUTOMATIC MIXING PAINT TANK H8226 - Manual (Page 10)

Model H8226 5 Gallon Automatic Mixing Paint Tank -8 -
OPERATIONS
Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.
To use your paint tank:
1. Thoroughly mix and strain your paint
to remove undissolved particles that
could block the flow of material to the
gun.
2. Pour paint into the tank.
3. Place the lid assembly on the tank and
evenly hand tighten the lid clamp but-
terfly nuts.
4. Adjust the regulator at your air com-
pressor to 50 PSI.
5. Fully turn the paint tank regulator knob
counterclockwise to shut OFF the tank
regulator.
6. Connect the paint tank to the air com-
pressor.
7. Adjust the paint tank to 20 PSI on the
tank gauge. Normal operating tank
pressure is 20–30 PSI. Using trial and
error, adjust the paint tank as neces-
sary between this range for optimum
results.
8. Adjust the regulator at the spray gun.
9. Start by testing the spray gun at a low
setting, then increase the air pressure
as needed for satisfactory results.
Tank Setup