Grizzly H2910 - Manual (Page 7)

H2910 3-IN-1 WOOD, METAL & CONCRETE NAILER -6 -
OPERATION
Loading The Nailer
Depth Adjustment
Operating The Nailer
To load your nailer:
1. Disconnect the air supply from the
nailer!
2. Push the magazine latch in the direc-
tion shown in Figure 1 .
Figure 1. Releasing magazine latch.
Figure 3. Depth adjustment wheel.
Figure 2. Loading the nailer.
5. Push the magazine cover forward
until the magazine latch locks in
place.
1. Rotate the depth adjustment wheel
(shown in
Figure 3 ) clockwise to
increase the nail driving depth.
2. Rotate the finger wheel counter-clock-
wise to decrease the nail driving
depth.
If you have not read the safety instruc-
tions in this manual, do not operate the
nailer.
Before you operate your nailer, place one
drop of the included oil into the quick con-
nect fitting where the nailer connects to the
air supply. Fire the EMPTY nailer 3-4 times
before beginning, so oil does not come out
onto the project during regular operation.
3. Pull back the magazine cover until it
stops.
4. Point the nailer down and insert a
stick of brad nails into the magazine
as shown in Figure 2 . Make sure that
the pointed ends of the nails rest in
the slot at the bottom of the magazine.