Grizzly H5676 - Manual (Page 2)

-2-
h5676 2-Speed rechargeable Screwdriver
identification
refer to figure 2 and the following descrip-
tion to become familiar with the features of your
rechargeable screwdriver.
figure 2. Model h5676 identification.
J
a
i
B
C
d
E
F
g
h
a. Work light: provides light when working in
dark areas.
b. light on/off switch: Enables/disables the
work light.
c. handle lock: When pushed forward, allows
the handle to rotate to a straight or 45° angle
working position.
d. direction selector: Selects the direction of
the screwdriver, and disables the screwdriver
when in the center position.
e. battery charger plug receptacle: allows
the screwdriver to connect to the charger.
f. screwdriver trigger: rotates bit when
pressed and stops bit rotation when
released.
g. speed selector: Controls bit rotation speed.
push the selector forward for a speed of 100
rpM and move it back for 300 rpM.
h. Wrist strap: provides an easy method of
carrying or storing the tool.
i. torque adjuster: adjusts the amount of
torque applied to the operation. twist the
adjuster clockwise to increase torque, and
counterclockwise to reduce it.
J. bit holder: Secures a standard hexagonical-
shank bit in the screwdriver. the base is
magnetized.
charging the battery
1. plug the battery charger into a grounded
110V outlet in a dry location.
2. place the screwdriver on a flat, stable, and
dry surface, then insert the charger's plug
into the receptacle at the base of the handle.
note: The red light at the base of the handle
will stay brightly lit when there is correct
power to the charger.
3. When the battery is charged, disconnect the
battery charger and store it in a safe, dry
location for the next use.
replacing the Work light bulb
1. Make sure the screwdriver is disconnected
from the battery charger and is turned OFF.
2. push the protective hood that is over the work
light bulb forward until it slides off the screw-
driver.
3. remove the old light bulb from the clamp,
install the new light bulb, then replace the
protective hood.
NOTICE
charge the battery for at least 3 hours
before using the screwdriver the first time.
NOTICE
to avoid damage to the screwdriver, only
use light bulbs that are rated for use with
3.6 volt batteries.
If you need help with your new rechargeable screw-
driver, call our Tech Support at: (570) 546-9663.