Grizzly H3368 - Manual (Page 12)

-10- H3368 Grinder/Sander Combo
Tool Rests Eye Shield & Spark Guard
The spark guard should be positioned 1 ⁄
8
" from the
grinding wheel to minimize sparks flying at the
operator. The eye shield must be positioned
between the grinding wheel and the operator’s
face to protect the operator from flying debris—
this is not a replacement for safety glasses!
To install the spark guard and eye shield:
1. Using the included 5mm screw and washer,
install the spark guard as shown in
Figure 7 .
Figure 6. Tool rest installed and positioned near
the grinding wheel.
Figure 7. Spark guard attached to rim guard.
Figure 8. Eye shield and support bracket attached.
2. Attach the eye shield to the support bracket
as shown in
Figure 8 with the included 6mm
carriage bolt, washer and hex nut. Use the
8mm hex bolt and washer to attach the sup-
port bracket to the right wheel cover.
The tool rest attaches to the inward side of the
guard and provides a surface that can be used to
support the workpiece during operation. Certain
types of grinding/sanding may require jigs or
accessories that will be used with the tool rests to
assure the proper angle of the workpiece against
the wheel.
To install the tool rests:
1. Attach the tool rests with the knob bolts and
5mm washers and hex nuts, without tighten-
ing them completely.
2. To adjust the angle of the sanding belt tool
rest, use a square or a protractor to set the
angle of the tool rest in relation to the sand-
ing belt.
As a general rule, set the tool rest
90˚ to the belt during the set up procedures.
3. Adjust both tool rests approximately 1 ⁄
16
"- 1 ⁄
8
"
from the grinding wheel and the sanding belt.
Figure 6 shows the correct adjustment for
the tool rest at the grinding wheel.
4. Tighten the tool rests.
Attach Spark
Guard Here
Attach Eye
Shield Here
Attach Support
Bracket Here