GE SPSD157JMG - Manual (Page 2)

For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000.
Special Installation Requirements:
Stacked Installation:
• Brackets for stacking dryer over washer are available at an additonal cost
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be
stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a
minimum of 60 sq. in. of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code,
ANSI Z223 for gas dryers.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides, 3" rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
Stacked Dimensions (in inches)
79 1/2"
27
15
29-1/2
Storage Pedestal Dimensions
(in inches)
SPSD157JMG - Champagne
SPSD157JWW - White
This optional 15" pedestal raises
the door opening and height of
the washer or dryer. Feet on 15"
pedestal allow it to adjust to 15-
3/8" height.
Listed by
Underwriters
Laboratories
Specification Revised 10/10 270182
PFDS450EL/PFDS455EL
GE Profile 7.5 cu. ft. stainless steel capacity frontload dryer with Steam