GE ZISW - Manual (Page 4)

ZISW/B480DR – GE Monogram 48" Built-In Side-by-Side Refrigerator
with Dispenser and Water Filter
Specification Revised 3/08
110179
1/4" Framed Panel Dimensions
If you choose to install framed panels,
they must be cut to the dimensions
shown. the panels will slide into the
frame on the door and grille.
If the custom panel is less than 1/4" thick,
and it fits loosely in the door frame, it can
be backed up with a piece of filler material
or foam tape to improve the fit.
Important Note:
Maximum total panel weight:
• Freezer food door panel – 75 lbs.
• Freezer door panel – 53 lbs.
• grille panel – 18 lbs.
9-5/8"
194Dia_63
Dispenser Cutout
15-3/8"
Dispenser Models
these refrigerators are supplied with two dispenser trims, one for
framed panels and one for overlay panels.
1/4" Framed Panel
the framed panel must be 1/4" nominal thickness to fit the
dispenser trim.
• the dispenser trim fits over the custom panel and snaps into the
freezer door.
• If the panel is less than 0.250" thick, a noticeable gap may be
created around the dispenser trim. Foam tape may be applied on
the door to improve the fit.
• If the panel is more than 0.250" thick, the dispenser trim cannot be
secured to the door.
1/4" Backer Panel
.10" Spacer
Panel
3/4" Overlay Dispenser Trim
3/4" Overlay
Panel
FREEZER DOOR 1.100"
Total
Thickness
Ice / Water Dispenser
696Dia4
3/4" Overlay Panels
the overlay dispenser trim is designed to fit a total panel thickness
of 1.100".
• If the panel is less than 1.100" thick, a noticeable gap may be
created around the dispenser trim.
• If the panel is more than 1.100" thick, the dispenser trim cannot be
secured to the door.
• the overlay panel must be constructed according to the specifications
shown to achieve the correct total thickness.
• Alternative panel construction methods such as securing a
3/4" panel to a 1/4" backer panel cannot be used. Another method,
routing a 3/4"-thick panel on all sides, cannot be used. these
methods will not result in the required 1.100" panel thickness.
• When a raised panel design is to be used, a custom middle rail
is required.
Listed by
Underwriters
Laboratories
As an EnErgy StAr ®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
For answers to your Monogram, ® gE Profile ™ or
gE ® appliance questions, visit our website at
gEAppliances.com or call
gE Answer Center ® service, 800.626.2000.
696Dia3
1/4"
Framed
Panel
1/4" Dispenser Trim
0.250"
Thick
Ice / Water Dispenser
FREEZER DOOR
194Dia_59
Door
5/16"
Trim
Reveal
1/4"
Panel
194Dia64
Fresh Food
Panel
Freezer
Panel
26-9/16" 18-9/16"
17-13/16"
5-1/8"
45-7/8"
9-1/2" Grille Panel
68-3/8"
Dispenser
Cutout