Generac MPSG350 - Manual (Page 4)

INTERCONNECTION DIAGRAM
PMIC Power Manager Integrated Control
PMSC Power Manager System Control
DISTRIBUTED BY:
GENERAC POWER SYSTEMS, INC.
MPSG350
The PM-SC can control 3 transfer switches and any number of
slave switches. The main connection box would be configured for
the size and number of wires for the specific application.
1 - 200 kW 13.3 Liter
+ 1 - 150 kW 13.3 Liter Gas
Powered Generator
Modules
The PM-IC is part of the Generac Transfer Switch
A connection box for the power wires is an option.
GENERAC POWER SYSTEMS,INC.
P.O.BOX 8 WAUKESHA, WI. 53187
262-544-4811 FAX 262-544-0770
©
2003 GENERAC POWER SYSTEMS, INC. All rights reserved. All specifications subject to change without notice. Bulletin # 0168230SBY MW 06-28-03
Typical Installations
Area Space Requirements.
Units can be placed end to end, side by side or wherever room is available. The transfer switch or switches are generally placed
close to the main electric service. Consult State, Federal and Local codes for specific installation requirements.
Power Connections are in one area in the left rear quadrant of the genset.
All controls are through a single 2 wire RS485 connection that can be daisy chained between generators.
Generator Generator
ATS ATS ATS
Power
Manager
System
Control
(PM-SC)
Control Wiring
Power Wiring
Gen Bus or
Connection
Cabinet (Opt)
Generator Generator
Power Manager
Integrated
Control
Transfer
Switch
control
power power
control
Standard Enclosed units shown.
Sound attenuated package adds an
additional 26" to the length.
Units can also be non-enclosed for
indoor installations.
AIR AND
EXHAUST
OUTLET
TOP SIDE
TOP VIEW
13.3 LITER
AIR AND
EXHAUST
OUTLET
TOP SIDE
TOP VIEW
13.3 LITER
Minimum Clearance
between units
Electrical
Connections
this area
Electrical
Connections
this area