Grizzly G0573 - Manual (Page 8)

-6-
G0573 Two Speed Floor Air Filter
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110V Operation
Amperage Draw
The 1 3 ⁄
4
HP motor on the Model G0573 will draw
the following amps:
Motor Load ....................................... 12-14 Amps
Circuit Breaker Requirements
Install your machine on a dedicated circuit to
reduce the possibility of tripping the circuit break-
er. If the circuit breaker frequently trips, have the
circuit inspected by a qualified electrician. Never
use a larger circuit breaker than stated below, or
you will increase the risk of fire.
Circuit Breaker .........................................15 Amp
Plug Type
The Model G0573 is supplied with an inverted-
type 5-15 plug. You must insert an extension cord
receptacle over the inverted plug and then insert
the male part of the extension cord into a 5-15
wall receptacle.
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
• Make sure the cord is rated Standard Service
(grade S) or better.
• The extension cord must contain a ground
wire and plug pin.
• Use at least a 16 gauge cord.
• DO NOT use a cord longer than 50 feet! .
SECTION 2: CIRCUIT REQUIREMENTS
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!