Grizzly Nursery Wagon with Wood Sides H3029 - Manual (Page 3)

fRONT AXLE ASSEMbLY
1. With the bed turned upside down, fasten
the front and rear axles ( figure 2) to the
bed with four M8-1.25 x 20 hex bolts, flat
washers, and lock nuts. the hex nuts should
face up and the front axle steering supports
should point toward the rear of the cart.
ASSEMbLY INSTRUCTIONS
figure 2. Axles mounted to the bed.
2. place the steering bracket (figure 3) over
the front axle so the longer length of the
bracket lays over the top of the axle, insert
the front axle stud (
figure 3) through the
short length of the bracket, and secure with
a cotter pin.
figure 3. Front axle assembly.
rear Axle
Assembly
Front Axle
Assembly
steering
Bar
3. Fasten the steering brace to the bed with two
M8-1.25 x 20 hex bolts, flat washers, and
lock nuts.
4. insert an M6-1 x 20 hex bolt through the
steering brace, the axle, and the steering
bracket and secure with a flat washer and
lock nut.
5. place the steering bar under the steering
supports and steering bracket, and secure
with M6-1 x 16 hex bolts, flat washers, and
lock nuts as shown in
figure 3.
REAR AXLE ASSEMbLY & WHEELS
1. slide a rear axle brace onto each rear axle
and bolt the ends of the braces to the bed
using the remaining M8-1.25 x 20 hex bolts,
flat washers, and lock nuts, as shown in the
parts breakdown.
2. slide a tire and a 16mm flat washer over
each axle with the tire valve stems facing
outward. insert a cotter pin into each axle
and spread.
pULL HANDLE & WOOD SIDES
1. insert the end of the pull handle through
the plastic coupling and mount these to the
front of the steering bracket with a slot head
screw, flat washer, and lock nut.
2. turn the cart over and fasten the metal
brackets to the outside edge of the cart with
M6-1 x 16 flat head screws, flat washers, and
acorn nuts.
3. slide the front, rear, and side panels into the
brackets.
If you need additional help with this procedure,
call our Service Department at: (570) 546-9663.
steering
supports
steering
Brace
Front
Axle stud
short
length
steering
Bracket
long
length
Axle