Grizzly H0582 - Manual

Specifications
Drive Size .......................................................... 1"
Bolt Size Capacity .......................................... 1
3 ⁄
4
"
No-Load Speed .................................. 3,800 RPM
Maximum Torque ................................. 1,200 ft/lb
Air Inlet Size .............................................
1 ⁄
4
" NPT
Air Consumption ...................................... 12 CFM
Operating Pressure ................................... 90 PSI
Maximum Operating Pressure ................. 120 PSI
Weight ....................................................12.75 lbs
Inventory
A. Impact Wrench ........................................... 1
B. Handle ........................................................ 1
C. Nut .............................................................. 1
Setup
Secure the handle to the impact wrench with the
nut, so the assembled tool looks like
Figure 1.
MODEL H0582
1" HEAVY–DUTY
PIN-CLUTCH
IMPACT WRENCH
INSTRUCTION SHEET
COPyRIgHT © OCTOBER, 2008 By gRIzzLy INDuSTRIAL, INC.
WARNINg: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF gRIzzLY INDUSTRIAL, INC.
#TR11306 PRINTED IN TAIWAN
INJURY HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
DO NOT EXCEED 120 PSI!
Personal injury could
occur.
SHATTERINg HAzARD!
Use sockets rated for
impact wrench use only.
Operation
For best performance, connect your wrench to
the air supply with a
1 ⁄
2
" air line and fittings. Slide
the forward/reverse switch left or right to make
the wrench turn clockwise or counterclockwise.
Adjust the throttle dial to increase or decrease
torque.
Maintenance
The impact wrench MuST be regularly lubricated
with 3-4 drops of air tool oil directly into the air fit-
ting before each use. For best results, we recom-
mend using an in line filter, lubricator, and regula-
tor, as shown in
Figure 2.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2 . Installing your tool.
Handle
Forward/Reverse
Switch
Throttle Dial
Figure 1. Model H0582