Grizzly 12" Slip Roll G7148 - Manual (Page 6)

-4- G7148 12" Slip Roll
Using The Slip Roll
1. Perform all adjustments as required by the
material thickness and whether you are
engaging in straight rolls or cones.
2. Insert material edge between the fixed shaft
and the front movable shaft.
3. Turn the handle to process the material.
4. If you are only performing partial rolls and
need to remove the material, slide out
release rod shown in
Figure 2 and pull the
fixed shaft forward. You can now remove the
material from the slip roll.
SECTION 6: OPERATION
Keep loose clothing
rolled up and out of the
way of rollers and keep
hair pulled back. Wear safety glasses dur-
ing all operations on the
slip roll. Failure to com-
ply may result in serious
personal injury.
Forming Wires
1. To form wires, select the smallest groove
that you can use (see grooves shown in
Figure 3 ) and put the edge of that wire on
the groove of the front movable shaft.
2. Turn the handle to process the wire.
3. If you are only rolling part of the wire, slide
out the release rod and pull the fixed shaft
forward. You can now remove the wire from
the slip roll.
4. If you want to form rings from wire, process
the wire until the end meets the length of the
stock. Remove the fixed shaft and cut the
wire where the end meets it.
Figure 2.
Figure 3. Wire grooves.
Shaft
Release
Rod