Installing the anti-tip, Floor bracket , 19, Warning – GE 49-60612 User Manual

Page 18: Locating the anti-tip floor bracket, Figure 1 – installation overview, On 21 ft. models)

Advertising
background image

LOCATING THE ANTI-TIP

FLOOR BRACKET

Place the anti-tip floor bracket locator template

(included inside the anti-tip kit) onto the floor

up against the rear wall, within W, and in line

with the desired location of the RH side of the

refrigerator (see Figure 1).

Place the anti-tip floor bracket onto the locator

template with its RH floor holes lined up with

the floor holes indicated on the template sheet,

approximately 7

1

4

from the edge of the sheet

or the RH side of the refrigerator.
Hold down in position and use the anti-tip floor

bracket as a template for marking the holes

based upon your configuration and type of

construction as shown in Step 3. Mark the hole

locations with a pencil, nail or awl.
NOTE:
• It is REQUIRED to use at least 2 screws to

mount the floor bracket (one on each side of

the anti-tip floor bracket). Both must be into

either the wall or the floor. Figure 2 indicates

all the acceptable mounting configurations

for screws. Identify the screw holes on the

anti-tip floor bracket for your configuration.

MEASURE CABINET OPENING

AVAILABLE VS. REFRIGERATOR WIDTH

Measure width of cabinet opening where

refrigerator will be placed, W.
Be sure to account for any countertop

overhang, baseboard thickness and any

clearance desired. Width, W, should not be less

than 36 inches. The refrigerator will be placed

approximately in the middle of this opening.

WARNING

Under certain circumstances, this refrigerator

can tip forward.
Injury to persons can result.
Install Anti-Tip Bracket packed with this

refrigerator.

1

Baseboard
Thickness
or Countertop
Overhang
(Whichever
Is Greater) Plus
Any Desired
Clearance

Rear Wall

Front

RH Side

2

A

B

C

W

Base
Bracket
on the
Refrigerator

2 Wall Holes

RH Side of
Refrigerator

Floor – Concrete
(2 Holes)

Floor – Wood
(2 Holes)

7

1

4

Locator Template
Sheet

Floor Bracket
to Install

RH Holes

Rear RH Corner
of Cabinet Wall

REFRIGERATOR

Figure 1 – Installation Overview

18

Installation Instructions

INSTALLING THE ANTI-TIP FLOOR BRACKET

(on 21 ft. models)

Advertising
This manual is related to the following products: