Step 5, connect electrical, Step 6, assemble burners, check ignition, Installation – GE ZGU48L6R User Manual
Page 9: Connect electrical, Step 5 assemble burners, check ignition step 6
Assemble burners as shown. Check to be sure that
burner heads and caps are securely seated. Pin(s) must
completely engage holes to ensure proper assembly.
• Check for proper ignition:
– Push in one control knob and turn 90° to Lite position.
– The igniter will spark and the burner will light; the
igniter will cease sparking when the burner is lit.
– First test may require some time while air is flushed
out of the gas line.
– Turn knob to OFF.
– Repeat the procedure for each burner.
IMPORTANT: If the igniter electrodes continue to
spark after the burners are lit, check that each
burner component is assembled and seated properly
by observing constant gaps between each layer.
Disassemble and reassemble as required.
• Burner flames should be blue and stable with no yellow
or yellow tips, excessive noise or lifting of the flame
from the burner. If any of these conditions exist, check
that the burner ports are not blocked.
To aid reassembly, each brass burner head is
marked with a clock face. Replace the burner
head with the arrow pointing to the rear of the
cooktop (12 o’clock position).
Burner Head
(Brass)
Locator Pins
Burner Ring
(Aluminum)
Burner Cap
9
CONNECT ELECTRICAL
Plug power cord into properly grounded receptacle.
STEP 5
ASSEMBLE BURNERS, CHECK IGNITION
STEP 6
Installation