Gefen TSE100 User Manual
Page 6
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE TSE100 SYSTEM.
1. WARNING!: The TSE100 were designed to operate on
Macintosh computers. Do not attempt to use this equipment
with any other type computers.
2. The TSE100S is shipped with monitor switch setting for
640X480 resolution. For details on how to change the default
setting, refer to page 11.
3. WARNING!: When using a local keyboard not extended
with the TSE100S unit, use the Gefen modified ADB cable.
Modified cable is connected between the TSE100S sender and
the local keyboard or mouse.
3. WARNING!: When plugging in a TSE100 Sender unit
ONLY, without the TSE100 receiver unit, the keyboard and
mouse will freeze. The TSE100 Receiver unit must be
connected, and powered up, and the link cable installed
between both units, in order to operate property.
4. When using the TSE100 with two monitors, one extended
and one local, both monitors MUST be the same type. If the
monitors are different, they will not initialize correctly.
5. Link Cable: Refer to the wiring diagram on page 10 for
wiring instructions.
2