Gefen EXT-HDMI1.3-1CAT6 - Manual (Page 11)

8
How to Connect the Extender for HDMI 1.3 over one CAT6
1. Connect a HDMI cable (one is supplied) between the HDMI output on a
HDMI source device and the HDMI input on the Extender for HDMI 1.3 over
one CAT6 sending unit
.
2. Connect a single CAT-6a cable between the sending and receiving units.
NOTE:
When f eld terminating CAT-6a cabling please adhere to the TIA/EIA-
568-B specif cation. Please see page 11 for more information.
3. Connect a HDMI cable (user supplied) between the HDMI input on a HDMI
capable output device (i.e. HDMI display) and the HDMI output on the
Extender for HDMI 1.3 over one CAT6 receiving unit
.
4. Connect the included 5V DC power supplies (two are included) between the
sending and receiving units and open wall power sockets.
5. Initialize the HDMI output device (i.e. HDMI display) f rst and the HDMI
source device last.
How to Equalize the Extender for HDMI 1.3 over one CAT6
The Extender for HDMI 1.3 over one CAT6 receiving unit has a equalization
Trim to compensate for the extension distance and the quality/skew variances that
are found in different CAT-6a cabling brands. If there is no output video or if output
video has video artifacting and/or video noise, please use the steps below to adjust
the equalization trimpot.
1. Insert a small f at head tool into the trimpot on the front panel of the
receiver unit
.
2. The trimpot has 8 set positions. Turn the trimpot in a clockwise fashion until
it clicks into the next position. Continue adjusting the trimpot by trying all 8
positions until the issue is resolved.
3. Carefully remove the adjustment tool.
CONNECTING AND OPERATING THE EXTENDER