GE ZV800 - Manual (Page 23)

23
Installation Instructions
CONNECT ELECTRICAL
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be sure
to use U.L. approved anti-oxidant compound and
aluminum-to-copper connectors.
ADVERTISSEMENT :
Si la maison n’est pas câblee avec deux fils et un fil de
terre, l’installateur doit installer un fil de terre. Quand
les fils sont en aluminium, il faut prendre soin d’utiliser
des connecteurs aluminium à cuivre avec une pâte
antioxydante approuvée par U.L.
• Remove junction box cover and knockout.
• Use a conduit connector to secure the conduit to
the junction box.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
lead or bare ground lead.
• Secure all connections with wire nuts on each
electrical connector.
• Push wires into junction box and replace cover.
Be sure wires are not pinched.
• Secure electrical panel cover with screws provided.
8 INSTALL FILTERS
• Remove protective film on the filters.
NOTE: It is not necessary to install the charcoal filter
in a vented installation.
• Tip the filter into the slots at the rear of the opening.
Lift the filter lock and pull forward until the filter
rests in the slots.
• Install both metal grease filters.
• To remove the filters, press inwards on the handle
and pull the filter downwards.
10
Filter Locks
INSTALL REAR MOUNTING
SCREWS
• Pull the glass canopy forward to access and install
2 wood screws or fasteners through the bottom of
the hood and into the wall.
9
Install 2 Wood Screws
UNDER-CABINET INSTALLATION