GE RM24948 - Manual (Page 3)

5 4
1. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
2. Press and release the desired device
button (TV, VCR/DVD, etc.). The red
indicator blinks, then stays lit.
3. Enter the 4 digit code for
your brand of TV, VCR,
etc., from the Library Code
Table by using the CH-, V-,
CH+ and V+ buttons.
Use the CH- button to enter the first digit.
Use the V- button to enter second digit.
Use the CH+ button to enter the third digit.
Use the V+ button to enter the fourth digit.
For Example: To enter code 0107, don’t
press CH-, press V- once, don’t press CH+
and press V+ seven times. The red LED
blinks off with each keypress.
CHANNEL Up/Down
Changes the channels.
Also controls DVD SKIP
functions.
POWER Turns
product On or Off.
VOLUME UP/DOWN
Changes the volume
level of the product,
normally the TV.
SETUP Used to setup
the remote, and for
code search function.
MUTE Turns off the
TV sound, while the
picture remains.
TV, CBL/AUX, VCR/DVD
Selects product to be
operated.
Red Indicator
Lights when any
button is pressed.
Note: The REC button must be pressed TWICE to
record from your VCR. For some brands of VCRs,
you might need to press the REC button once, then
press it again for three seconds.
RECORD, PLAY, STOP,
REW, FF, PAUSE VCR/DVD
control buttons operate
your VCR or DVD even
when the remote is set to
operate the TV.
Button Functions Code Entry using the Code List
4. Press the MUTE button to save the
code.
Note: for a valid code, the red LED turns off. For an
invalid code, the red LED blinks rapidly for three
seconds before going off.
5. With your device on, press POWER. If the
device turns off, no further programming is
required. Note: If some buttons do not
operate your equipment, try one of the
other codes for your brand.