Grizzly POLAR BEAR G0453P - Manual (Page 27)

-17- Model G0453Z/G0454Z (Mfg. 1/09+)
figure 9. installing the table height handwheel.
figure 10. dust hood attached.
4. place the bushing on the handwheel shaft.
5. insert the key into the shaft keyway.
6. screw the handle into the handwheel.
7. place the handwheel on the shaft and secure
it with the M12-1.75 hex nut and 12mm flat
washer, as shown in
figure 9.
8. Model G0453Z: Attach the dust hood to the
top of the planer with (3) M6-1 x 10 hex bolts,
6mm flat washers, and M6-1 hex nuts as
shown in
figure 10, then attach the bottom of
the dust hood to the planer with the M8-1.25
x 20 cap screws.
Note: You will need to reach into the dust
hood to hold the hex nuts while tightening the
hex bolts.
Model G0454Z: Attach the dust hood with
the provided (6) M6-1 x 12 flange bolts.
9. remove the hex bolt, and hex nut that are
pre-installed in the foot pedal bracket (see
figure 11).
figure 11. Foot pedal and caster installed.
hex Bolt & nut
Bracket
Foot pedal
Caster
pin, E-Clip
& Washers
10. Align the holes of the caster assembly and
foot pedal bracket with those of the mounting
flange, then insert the hex bolt through the
holes and secure it with the hex nut.
Note: Tighten the hex bolt just enough for it
to be snug without hampering the pivot action
of the bracket.
11. remove the pin, flat washers, and E-clip from
the foot pedal bracket, align the foot pedal
holes with the bracket, then re-install the pin,
flat washers, and E-clip.