Grizzly Heavy-Duty Roller Stand T10114 - Manual

MODEL T10114
HEAVY-DUTY
ROLLER STAND
INSTRUCTIONS
Introduction
The Model T10114 Heavy-Duty Roller Stand is
vertically adjustable from 26
1 ⁄
4
" to 41" with the
use of a crank handle and the attached elevation
gears, as shown in
Figure 1. This stand has a 270
lb. capacity.
Assembly
Refer to Figure 1 and the Parts Breakdown illus-
tration to aid you during assembly.
Tools Needed Qty
Phillips Screwdriver ........................................... 1
Hex Wrench 3mm .............................................. 1
Wrench or Socket 10, 13mm ....................1 Each
To assemble your roller stand:
1. Thread the four foot pads into the base.
2. Secure the bottom vertical support onto the
base by threading the 3 ⁄
8
"-16 x 1" hex bolt,
lock washers, and flat washers through the
bottom of the base and into the support.
3. Insert the top vertical support into the bottom
support with the horizontal slits facing toward
the gear assembly mounting.
4. Position the elevation gearbox onto its mount-
ing point and make sure the gear teeth mesh
with the slits in the top vertical support, then
secure the gearbox with the four
1 ⁄
4
"-20 x 1 ⁄
2
"
Phillips head screws.
5. Align the set screw in the crank handle hub
with the flat of the gear assembly shaft, slide
the crank onto the shaft, then tighten the set
screw to secure it in place.
6. Thread the two lock knobs into the holes on
the side of the bottom support.
7. Attach the roller bracket to the top verti-
cal support with the four 1 ⁄
4
"-20 x 1 ⁄
2
" flange
bolts.
8. Insert one side of the roller axle into a mount-
ing hole on the roller bracket, then push in on
the other end of the spring-loaded axle until
you can insert it into the remaining mounting
hole.
Inventory
After removing the contents of the shipping
package, lay them out and refer to the
Parts
Breakdown on the back page to inventory the
components.
If you need help with your new roller stand, call
our Tech Support at: (570) 546-9663.
Figure 1. Model T10114 identification.
Roller Lock
Knob
Adjustable Foot Pad
Elevation
Gearbox
Crank
Handle