Golden Technologies GB 101 - Manual (Page 14)

Buzzaround Owner’s Manual - Updated 092605
Page 14
OPERATION
Armrest Width Adjustment
To adjust the armrest width:
1. Loosen the adjustment knobs at the rear of the seat.
2. Slide the armrests in or out to the desired width.
3. Tighten the adjustment knobs.
Seat Height Adjustment
To adjust the seat height:
1. Remove the seat by lifting it straight up.
2. Set the seat aside.
3. Remove the bolt, nut, and washers that hold the
seat post in the seat pedestal or ball detent pin.
4. Position the seat post at the desired height while
aligning the holes in the seat post and the seat pedestal.
5. Reinstall the nut, bolt, and washers and tighten securely,
or the ball detent pin.
WARNING: WHEN RAISING SEAT TO ITS HIGHEST POSITION
REFERENCE TIPPING ANGLE ON PAGE 6. THIS SCOOTER
WILL TIP EASIER WHEN THE SEAT IS IN ITS HIGHEST POSITION.
Seat Rotation Lever
The seat can be rotated through 360
° and locked at any
45
° position.
1. Pull up on the seat rotate lever and rotate the seat
to the desired position.
2. Release the handle to lock the seat at any 45
° position.
WARNING: DO NOT ATTEMPT TO DRIVE YOUR BUZZAROUND
IN ANY SEAT POSITION OTHER THAN FULLY FORWARD.
Flip-Up Armrests
Pull up on the end of either armrest to flip it up for easy
transfer on and off your Golden Buzzaround.
Seating
The Golden Buzzaround seat is available in black vinyl. Seats
for the Companion scooter will also fit the Buzzaround.