Grizzly G5955 - Manual (Page 14)

-12- G5955 Heavy-Duty Hanging Air Filter
Mounting Cleats
The hanging air filter may
fall and cause serious
injury if it is not properly
mounted. DO NOT fasten it
to sheet rock, press board,
paneling or anything other
than joists or studs.
Components and Hardware Needed Qty
2" x 4" Stock ..................................................5'-8'
3" - #10 Deck Screws ......................................12
Tools Needed
Saw ..................................................................1
Drill ....................................................................1
Phillips Screw Driver ..........................................1
1 ⁄
4
" Drill Bit ..........................................................1
The following describes mounting the hanging air
filter on the ceiling. Spacing for studs will be dif-
ferent and adjustments to the lengths listed here
can be made to accommodate hanging the unit
on a wall or at an angle on the ceiling.
The spacing for the mounting brackets on the
hanging air filter is 18" and 31" on centers. The air
filter must be attached to joists or studs. To do so,
attach cleats across the joist/stud and attach the
hanging air filter to the cleats. Please refer to
Figures 7 and 8 while following these instruc-
tions:
1. If the ceiling has sheet rock or some other
covering on it, locate the joists with a stud
finder and mark their centers.
2. Make reference marks on the joists or ceiling
for the cleat layout at either 18" or 31" cen-
ters.
Components and Hardware Needed Qty
Mounting Brackets ............................................4
Hex Bolts
1 ⁄
4
"-20 X 1 ⁄
4
" ........................................8
Tools Needed
Wrench 10mm ..................................................1
To attach the mounting brackets:
1. Attach one mounting bracket to each corner
of the hanging air filter using the 8 hex bolts
and the holes on the edge of the box. Make
sure to mount each bracket below the edge
of the box as in
Figure 6 . This will ensure it
is properly supported.
Figure 6. Mounting brackets attached.
The hanging air filter may
fall and cause serious
injury if it is not properly
mounted. These mount-
ing brackets must be
attached to the bottom
edge on the upper lip of
hanging air filter to be
safely supported.
Mounting Brackets