Gefen EXT-COMPAUD-CAT5-444 - Manual (Page 17)

14
OPTIONAL REMOTE CONTROL INSTALLATION
1. Remove battery cover from the back of the RMT-16IR remote.
2. Verify that DIP switches 1 & 2 are in the down (OFF) position.
3. Insert the battery, hold the battery so that you can see the positive side facing
up. The side that is not marked must be facing down.
4. Test the RMT-16-IR remote by pressing ONLY one button at a time. The
indicator light on the remote will fl ash once each time you press a button.
WARNING: Do not press multiple buttons simultaneously and do NOT press buttons
rapidly. These actions will cause the remote to reset and steps 1-4 will have to be
repeated.
NOTE: The RMT-16-IR ships with two batteries. One battery is required for
operation, the second battery is a spare.
Empty
Battery
Slot
DIP
Switches
Above: Picture of the opened rear battery compartment of the optional
RMT-16IR remote showing the exposed DIP Switch bank between the
battery chambers.
y
hes